Established in 2006, TAT ELECTRONICS CO., LTD is a professional manufacturer specializing in electroacoustic components and electronic parts. With years of industry experience, TAT has remained committed to the research, development, and manufacturing of advanced electroacoustic technologies for global markets.
Our main product portfolio includes buzzers, micro speakers, alarms, receivers, microphones, connectors, inductors, and related electronic components. Serving both domestic and international customers, our products are widely exported to the United States, South Korea, Germany, France, and other overseas markets.
Certified with RoHS environmental standards and operating under the ISO9001 quality management system, TAT provides reliable and cost-effective products that are widely used in mobile communication devices, consumer electronics, household appliances, medical equipment, electronic toys, and security alarm systems.
Backed by professional engineering expertise, mature management systems, and a skilled workforce, TAT continues to strengthen its competitiveness in the electroacoustic industry through continuous innovation, efficient production, and customer-oriented service.
Seven questions that separate a real piezo buzzer manufacturer from a trading desk: who sinters the ceramic, how loudness is measured, how frequency holds across batches, and what happens when a batch fails inspection.
A buzzer and a speaker are not two versions of the same component, and treating them as interchangeable is one of the more expensive habits in embedded audio design. A buzzer is a narrow-band signalling device built to produce one unmistakable tone at the lowest possible current. A speaker is a wide
A piezoelectric buzzer and a magnetic buzzer differ in seven measurable ways, and they all trace back to one structural fact: the piezo part has no moving coil, and the magnetic part has no ceramic element. That single difference sets the voltage window, the current draw, the drive circuit topology,
A 14 mm passive piezo buzzer rated 85 dB at 10 cm and 5 mA at 12 Vp-p, with a potted top and 7.6 mm pin pitch. Five reasons it still suits alarm panels, plus the 4 kHz square wave it needs and the four dimensions that decide drop-in fit.
A board comes off the line fully populated, AOI is clean, and the unit still fails the audio test: the alert is faint, hollow, or missing entirely. In most of these cases the culprit is not the component itself. It is one of four things around it — the drive.
Wearable audio designs keep getting thinner, and the microphone is often the part that decides whether the housing can close. A 4015-size electret condenser microphone gives you a Φ4.0 x 1.5 mm capsule that weighs no more than 0.2 g, runs from a standard 2 V.
Most audio problems in handheld products are not audio problems at all. They are mechanical ones. The board is done, the firmware is done, and then someone measures the internal height above the battery and finds there is 4 mm where the speaker was supposed.